Lower bars?

When pressing on a bit start to feel like a hang glider pilot so thinking about lower/narrower bars.
Only prob is the damping adjusters on top of the forks prevents me putting flatter bars on. Don't want to go the clip on route if I can help it. I could make taller risers then fit flatter bars but I'll probably end up back where I started height wise.

Any suggestions?

I have seen some strange bars which go out, then up, then drop like clip-ons, but not sure where!

Or buy clip-ons!

3rd option, I have a set of non-adjustable forks (which have been tweaked a bit by Dave Wood Racing) which would give you the room to fit lower bars.