Oberon Clutch slave leaking

Mr Gazza · 25-01-2018, 05:22 PM

I bit the bullet and ordered a pinned 335mm rod from Moto Rapido yesterday.
It arrived this morning, less than 24 hours later...

I had to smile when I saw the label; the Italian for "Clutch Control Rod" is "Asta Comando Frizione".... I'll have to be careful not to put it in the wrong bike!!...

Anyway I'll do a detailed post in "Mods & how to's" when it's all fitted and had a good test run.
I'm fitting a new thrust pin in the pressure plate bearing too, as the old one looks a bit sorry and no longer fits in the bearing properly. Might change the bearing again as well, as this one never did spin, what I'd call freely... The seals seem very draggy?

Also need to change the oil and see if it stays clean any longer.

Part No. is 11721122A for the pinned 335mm rod, it comes complete with pin and two O-rings fitted.

25-01-2018, 05:22 PM	#31
Mr Gazza Lord of the Rings Join Date: May 2013 Location: Norwich Bike: M900sie Posts: 5,834	I bit the bullet and ordered a pinned 335mm rod from Moto Rapido yesterday. It arrived this morning, less than 24 hours later... I had to smile when I saw the label; the Italian for "Clutch Control Rod" is "Asta Comando Frizione".... I'll have to be careful not to put it in the wrong bike!!... Anyway I'll do a detailed post in "Mods & how to's" when it's all fitted and had a good test run. I'm fitting a new thrust pin in the pressure plate bearing too, as the old one looks a bit sorry and no longer fits in the bearing properly. Might change the bearing again as well, as this one never did spin, what I'd call freely... The seals seem very draggy? Also need to change the oil and see if it stays clean any longer. Part No. is 11721122A for the pinned 335mm rod, it comes complete with pin and two O-rings fitted. __________________