Setting the Gear Selector.

slob · 16-08-2021, 07:51 AM

the two holes on the tool fit over the pins on the selector drum and the edge of the tool lines up with a notch on the pawl. this tool has since been superceded by a different one (88713.3334), which i think is much harder to use.

if you’re eyes are good, getting the line on the pawl centred between two pins works fine.
just get a gear lever on the splines and mske sure you can run up and down the gears before putting everything else back in the case.

16-08-2021, 07:51 AM	#7
slob . Join Date: Jul 2003 Location: East London Bike: Multiple Monsters Posts: 9,714	the two holes on the tool fit over the pins on the selector drum and the edge of the tool lines up with a notch on the pawl. this tool has since been superceded by a different one (88713.3334), which i think is much harder to use. if you’re eyes are good, getting the line on the pawl centred between two pins works fine. just get a gear lever on the splines and mske sure you can run up and down the gears before putting everything else back in the case.