Make your own Case Saver

Mr Gazza · 21-04-2014, 06:53 PM

Mmm... It's tight alright.!

Ironicly there seems to be plenty of room either side of the pushrod boss...And that is where the chain would bunch in the event.

I am pondering an embryonic idea... Just wodering if it would be possible to have two guards in there?

One going as far as the boss from the top, and thinned down over the boss. and another below, picking up from beneath the top guard, ie, overlapping a bit. (or underlapping).

Each guard would need two mounting points each, I was wondering if it would be possible to use the clutch slave screws?
This would imply the use of a washer under the third slave screw to level things up, and probably a little spacer in the slave too, for the pushrod..!!!

All getting a bit complicated.! It might just keep the chain out of those holes though?

21-04-2014, 06:53 PM	#15
Mr Gazza Lord of the Rings Join Date: May 2013 Location: Norwich Bike: M900sie Posts: 5,834	Mmm... It's tight alright.! Ironicly there seems to be plenty of room either side of the pushrod boss...And that is where the chain would bunch in the event. I am pondering an embryonic idea... Just wodering if it would be possible to have two guards in there? One going as far as the boss from the top, and thinned down over the boss. and another below, picking up from beneath the top guard, ie, overlapping a bit. (or underlapping). Each guard would need two mounting points each, I was wondering if it would be possible to use the clutch slave screws? This would imply the use of a washer under the third slave screw to level things up, and probably a little spacer in the slave too, for the pushrod..!!! All getting a bit complicated.! It might just keep the chain out of those holes though?