UK Monster Owners Club Forum » .: Technical :. » Mods & How To's » Lock-down amusement?

Reply
 
Thread Tools Display Modes
Old 07-06-2020, 10:10 AM   #1
Bitza
Bronze Member
 
Bitza's Avatar
 
Join Date: Jul 2006
Location: Poole
Bike: M900ie
Posts: 464
Lock-down amusement?

Hi all, Well if anyone is looking for something to do to pass some time how about this "Blue Peterish" project? How to up-rate your "rear brake master cylinder push rod & clevis pin" from a M6 nut and 80 mm screw could be stainless or titanium. All you need is an electric drill & the usual set of hand tools hacksaw/file/emery cloth. So pretty self explanatory when you give it a little thought, first cut off enough thread & shank to make the push rod put into drill chuck and fashion taper & rounded end as per the original cut thread to length. Then take the head end and again into the drill and cut the circlip groove with the hacksaw and cut to length, then cut the head down to a disc. Finally cut the nut in half for the lock nut. Then just clean up the bits ready to fit, slightly better than the originals and where nobody will ever see anyway, time well wasted! Bitza

You could also splash out on a nice 5mm stainless circlip to boot, off ebay for not alot.

https://ibb.co/2NFPbtV
__________________
Bitza

Last edited by Bitza; 07-06-2020 at 10:31 AM..
Bitza is offline   Reply With Quote
Old 07-06-2020, 02:31 PM   #2
350TSS
Too much time on my hands member
 
350TSS's Avatar
 
Join Date: Jan 2013
Location: Shipbourne
Bike: M900
Posts: 1,417
I see you used titanium, bet it was not easy to cut the circlip groove with a hacksaw and only an electric drill, nice job though. I get the most satisfaction from little jobs like that, they cost very little but time and just make the bike that little bit better than it was.
350TSS is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 10:35 AM.

vBulletin Skins by vBmode.com. Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.