CF sprocket cover and short mud-guard.

[Saint aka ML]

Ok just found two bits I will not need so selling them.

A CF front sprocket cover - £20

A short mud-guard. This is where it gets tricky. It was not originaly for a monster. I had it modified to fit my old m750. I also had to have a small holl drilled in swing-arm, which then had to have been raised and threaded. However that depends on type of swing-arm some are flat so just a hole with thread is needed.

Not that hard took my mechanic like 30 min. - £30

Hey fella

I'm interest on the sprocket cover for sure if you still have it maybe the higher too if it fits

Dave

[Saint aka ML]

Originally Posted by monstark600

Hey fella

I'm interest on the sprocket cover for sure if you still have it maybe the higher too if it fits

Dave

Got both and sprocket cover was fitted to 1993 M900 so should fit all models defo M600.

Do not understand the second part of you message "maybe the higher too if it fits"

[slob]

damn you autocorrect! (hugger?)

[Saint aka ML]

Originally Posted by slob

damn you autocorrect! (hugger?)

Crap did not think about it

As said that hugger will fit only if you make an extra hole in swing-arm to mount it.
Depending from swing-arm it might be a hole + raising it abit (or you could use alloy spacer) or just hole. In either case threaded hole.

If you go for spacer idea then drill a hole, thread it and use correct spacer/spacers.