Ben's 900 Monster build

[Albie]

Drill and tap holes m6 in the same place. Take 2 black number plate screws the ones with the reduced front locatirs. These are the same size as the original lines.. Frome the back then screw the bolts through until the threaded portion stops the cut off the back with a chisel or sharp knife flat. You can glue but not necessary as plastic taps tight. Done a few now for customers of Proteam. Cost about 10p for bolts

[900Rebuilder]

Originally Posted by Albie

Drill and tap holes m6 in the same place. Take 2 black number plate screws the ones with the reduced front locatirs. These are the same size as the original lines.. Frome the back then screw the bolts through until the threaded portion stops the cut off the back with a chisel or sharp knife flat. You can glue but not necessary as plastic taps tight. Done a few now for customers of Proteam. Cost about 10p for bolts

Thanks - only just spotted this top-tip