Ventureshield

Okie dokie.

I put this on the bike today, and it was very straightforward. Definitely a two-person job, as you need someone to assist with the pieces, and spray as you peel.

Most pieces went on near perfectly, a bit of attention and fussing required to get a neat job, but nothing unexpected or unreasonable. I actually went on more easily over curves etc than I'd expected.

I ended up with one tiny bubble on the tank side I couldn't shift, but no bubbles or creases apart from that.

I (ably assisted by my wife) did:

Front mud-guard, both sides and front of the top (these are carbon, but it worked equally well).
Upper and lower headlight sections
Both tank sides

There are bits to do the rear cowl, which I will probably do, and the bikini fairing and trellis frame, which I probably won't.

As others have said, it's also effectively invisible now it's on.

Recommended!