Carb balancer - recommendations?

Nickj · 20-10-2018, 12:26 AM

There's overkill..

I have a bit of tubing with two restrictions (read smaller bit of tube) towards the middle where it's looped into a small coil. The balancing bit is a small bearing inside the tube.
Let the coiled bit dangle and the bearing sits the middle due to the magic of gravity.
Connect the ends to the intakes with adapters and off you go, just adjust till the bearing stays in the middle and all balanced.
Even done triples, V and in-line 4's with it.
Downside is the expense, probably under £5 as you tend to have to buy bearings in 10's. Oh and you do need some adapters.

20-10-2018, 12:26 AM	#4
Nickj Too much time on my hands member Join Date: Jun 2007 Location: Forest Of Dean Bike: S2r Posts: 3,196	There's overkill.. I have a bit of tubing with two restrictions (read smaller bit of tube) towards the middle where it's looped into a small coil. The balancing bit is a small bearing inside the tube. Let the coiled bit dangle and the bearing sits the middle due to the magic of gravity. Connect the ends to the intakes with adapters and off you go, just adjust till the bearing stays in the middle and all balanced. Even done triples, V and in-line 4's with it. Downside is the expense, probably under £5 as you tend to have to buy bearings in 10's. Oh and you do need some adapters. __________________ "The final measure of any rider's skill is the inverse ratio of his preferred Traveling Speed to the number of bad scars on his body." Song of the sausage creature