|
Thank you!
It's a new DP pressure plate, so the bearing should hopefully be fine! I dont think I greased the cap end of the push rod though so I'll make sure to do that. I'll also double check the stack height as it has been changed. I checked the little arrow lined up with the slot when I fitted the pressure plate.
The basket is basically new and the drum looks ok, the plates are all spotless too so I dont think it is anything to do with interference or sticking in between the clutch itself.
I'll double check the push rod length later on (and I'll make sure I did actually put in the spacer!��) but a new, longer push rod might not be a bad idea in the future.
I think it's going to be trial and error like you say, I'll start with checking measurements and I'll grease up the little cap. Then it is on to the bleeding (I would love to avoid doing this again)
Cheers
|