Ross090

Hi guys,

So I've done a bit of a clutch overhaul on my 93 M900, but I have a feeling that something is not quite right.

I've installed a Barnett clutch basket off a 1997 M900 that I used to own, as well as the plates from it which had very little use. I've also installed an Oberon slave cylinder, with the little insert on the pushrod, and I have a new master cylinder and lever on it too.

I've bled the system and I'm getting pressure - the handle feels fine. I'm able to go through the gears but when I pull the clutch in when in gear the pressure plate rotates and grabs the stack when I move the bike - I can't remember if is supposed to do this. I dont think it should.

Can someone please tell me if this is normal? Or if not, where is the first thing to check?

Thank you!