|
The idle speed can be adjusted by the throttle stop screw, I can send a diagram if needed. However, normally the stop position is set measuring the angle or voltage output from the TPS and then the idle speed is trimmed by using the air -bypass screws, this is how I set mine and ticks over perfectly.
If the engine ticks over and picks up smoothly then just adjust the stop to get the correct idle speed (easy), if it is eractic or rough then it's best to check the TPS setting, vacuum balance of the throttle bodies, stop position and then trim the idle with the by-pass screws....(not so easy).
Shaun
|