UK Monster Owners Club Forum - View Single Post - How to Prep for Paint after Soda Blasting?

30-03-2015, 09:56 AM

Some of you may have noticed my M900 rebuild in the UKMOC bikes section.
I've just sent my engine heads, barrels and bottom end away to be soda blasted.
My question is this:

What is the best way to prep the engine after soda blasting for paint?

I plan to use water and maybe lacquer thinners to wash and soda away. Then spray with VHT primer and engine enamel.
Do I need to key/sand/scuff the components or will the finish from soda blasting be adequate?

Any advice would be greatly appreciated...

30-03-2015, 09:56 AM	#1
ibanezlynx Guest Posts: n/a	How to Prep for Paint after Soda Blasting? Some of you may have noticed my M900 rebuild in the UKMOC bikes section. I've just sent my engine heads, barrels and bottom end away to be soda blasted. My question is this: What is the best way to prep the engine after soda blasting for paint? I plan to use water and maybe lacquer thinners to wash and soda away. Then spray with VHT primer and engine enamel. Do I need to key/sand/scuff the components or will the finish from soda blasting be adequate? Any advice would be greatly appreciated...