View Single Post
Old 03-02-2020, 08:30 PM   #10
The Clockie
Guest
 
Posts: n/a
Quote:
Originally Posted by rollo22 View Post
Nick
Have you been fiddling with the lever end ? and thus resulting in the master cylinder not moving back far enough to release the fluid back into the pot.

When putting the Oberon one on try without the clutch line connected and see ifit seats correctly. beware of fluid squirt.
It's not related to the lever end, because the hydraulic pipe is currently unattached from the slave and the system is empty of fluid!

Before I embark on cutting the push-rod down, can anyone advise on which end goes where? One has twin O-rings, the other doesn't. My ST4 workshop manual doesn't show the details but I may be able to find them in the parts list.

Nick
  Reply With Quote