Yeah I think I'll get it stripped down tomorrow and sent off. I assumed there were seals on the bearings as they're open to the elements otherwise? I saw someone quote a part number when I was reading earlier, 0755.49.265 for seals. Will do some investigating.
Will check for ovality of the pin, noted on the shims. I did take note that on the r/h side there was one thick and one thin shim, but on the left side just the one thick. I didn't think to check if the thick ones were both the same size, but they're now in an envelope... together. Bugger.
Parts manual lists bearings, seals and snap rings (?)
2: 0755.49.265 Anello di tenuta Seal ring
3: 76400.0004 Astuccio a rullini Needle bearing
4: 76266.2668 Anello elastico Snap ring
I'm assuming looking at the snap ring, that this is the lip people mention the bearings sitting up against, making them harder to knock out with a drift?
