[Nasher]

Thanks Saint.

Where did you, or Dukedesmo, mount the unit?
I’m aware the cable routing is sensitive.

I had a look yesterday, but because I wanted to get out and try it I just put it on top of the battery tucked under the rubber straps.
That’s obviously not ideal, but I can’t see where else to put it.

It won’t fit where one of the original IC Ignitors is currently, although I could make a new bracket and shunt the coils over to the Port side to make room.

The cable is long enough to run it back and put it under the saddle, but it’s too big to fit under there with the standard tool box lid in place in the bottom of the saddle.

I thought about making a bracket to mount it on the back of the battery tray, but that puts it right above the Vertical cylinder head and I’d be concerned about the heat.

The only places I can see are the gap alongside the suspension rocker, but I’d want to make a tray to fit it there, or behind one of the side panels, which I’d worry about if I was using the bike in the wet.

Nasher.