|
As always Vince you’re a legend. Thanks for the confirmation. No need for pillion pegs my wife and I have a 3 month old baby so bike time is a solo thing plus the back end looks so much cleaner without them.
Regarding the shock my dad and I spent a good hour just looking and throwing ideas about and the plan is as follows. 1. Using an air hacksaw cut the bolt on the right hand side of the shock first as there is a little more space that side. 2. Tap the shock across into the gap created. 3 cut the bolt again leaving as much of it sticking out of the swing arm as possible. 4. Make a guide bush for the drill bit to go through that fits tight to where the head of the shock bolt goes and also sits around the bolt sticking out of the swingarm the rest of the internal diameter being the same as that of the drill size for an m10 tap ready for re tapping the thread if a screw extractor still won’t get the bolt out. 5. Drill 6. Hope it’s not a cock up and a new swingarm needed
|