Back at work now so I'm able to start making a bit more progress putting the bike back together. Swing arm built back up and back onto the engine. The case bearings were packed with Aerospec 300 grease, so fingers crossed they will hold out. I had the sprocket carrier off the rear wheel to clean it up but noticed the bearings in the carrier aren't in a great way. Quite notchy, so £17 later from the local bearing supplier I have some new one.
Only I can't seem to get the old ones out, any tips? Are they just press fit? I've removed the circlip and tried tapping/hitting out with a nylon hammer, but they don't seem to move. I'll get a bit more aggressive with them when I know they're definitely press-fit. Anyone?
