After a week of sleeping a lot, I finally managed to get into the garage today and made some progress.
I fitted my rollers and some rubber edging to the infill panel on the frame and after a bit of fiddling and trimming got the battery tray to sit right with the frame and the wiring.
4 lengths of bicycle inner tube protect the looms as they pass through the infill panel and around the rollers and I managed to hang the excess loom from 2 large rubber "O" rings suspended from nylon "P" clips attached to the instrument mounting studs.
I had to lose my re-settable 25 amp main fuse as there just was not enough room for it, I am now waiting for a waterproof 25 amp fuse holder to go between the battery and the positive side of the MU unit.
I managed to confirm that my starter solenoid fires (clicks) OK and confirm that it does not matter which orientation the input leads are connected, just as well as I forgot to make a note of the wiring and colours to it.
