View Single Post
Old 25-10-2022, 10:36 AM   #11
Dukedesmo
Registered User
 
Dukedesmo's Avatar
 
Join Date: Sep 2010
Location: Leics
Bike: M900
Posts: 2,894
Quote:
Originally Posted by utopia View Post
And, on the pinch bolts .....
There have been many cases of the lower fork castings cracking due to the pinch bolts being tightened unevenly (and uneven tightening also leads to overtightening, which is part of the problem).
Therefore I would emphasise what has already been said about progressive tightening in an alternating sequence and also the use of moly grease on the threads.
Personally I start off by tightening them gently by hand with a normal allen key and I use something more like a 1-2-1-2-1-2-1 sequence to ensure that they are tightened absolutely evenly.
I only get the torque wrench out once this procedure has been completed (and even then I might torque them in two stages rather than giving them full torque in one go).
Also, using this procedure, I then reckon its ok to torque them to the lowest end of the recommended range.
Agree entirely.

I had some aftermarket PVM radial mounts fitted to 916 forks and they broke even using the recommended torque settings so be careful (but please leave the spindle nut in place, nice and tight).



Broke during a ride, though I didn't notice until I was home, they were very thin/lightweight metal though presumably for race application?

PVM's attitude was very unsympathetic BTW - "we've got one pair left we can sell you at an extortionate price" rather than addressing it in any way which was disappointing as I thought them to be better than that...
__________________
M900, 916, LeMans II.

Dukedesmo is offline   Reply With Quote