The plot thickens.
I’ve taken the clutch slave off again to check the push rod and this is what if find. Mind it’s not been started or ran from putting it back together earlier. (Pushrod rotates easily on both directions by hand with engine off and in neutral and with the bike running and in neutral. Can’t test it in gear.
screenshot windows 7
So the inner part that tight just fell out on removal. The inner part is actually threaded into the outer part. When i screw them back in together the indents are in the wrong position as you can see. Something catastrophic has happened I’m being to suspect a thrust bearing issue. I might have only done temporarily then freed itself off again. Dunno dunno dunno.