Thread
:
Another build thread - Ducati 1000
View Single Post
06-10-2021, 09:04 AM
#
146
buzzer
Registered User
Join Date: Jun 2018
Location: Wolverhampton
Bike: M900
Posts: 392
Starting to assemble the heads. New exhaust guides fitted as the originals were badly worn. I heated the heads up to remove and replace the guides, and made a tool to knock them in up to the register. It’s long enough to go through a guide in which is a snug fit in the valve seat so I can ensure it all goes in perfectly straight. Also I have a tool to fit the valve stem oil seals… if you use a socket it damages the rubber on the seal. Two of the rockers had started to peel the hard surface off… I have replaced with good second hand ones. My Dad bought me that tin of grinding paste 50 years ago…. I can vividly remember him sitting in the chair in our back room with a BSA Gold Star cylinder head on his lap grinding the valves in for me…. My mother looking on with disapproval it’s done well, only recently run out
buzzer
View Public Profile
Visit buzzer's homepage!
Find More Posts by buzzer