Hi there!
I have just picked up my old 1999 Monster 600 which has been sitting in a dry but unheated garage for 5 years. When I last used it it worked fine.
All the clutch fluid had leaked from the slave so I have a very shiny new Oberon slave cylinder to fit this weekend
I was planning on the following:
- Remove tank and drain
- Drain carbs using drain hoses
- Fit tank and add fresh fuel
- Drain some through the carbs
- Fit new battery
- Press go and crank until it maybe fires
- If it doesn't then think again
Is there anything else I need to do? I know it would be best to remove carbs etc but I am rubbish at that stuff...however if you think I could damage something then please let me know!!!
Will update after the weekend...hopefully without a full engine rebuild post...
Cheers!
Ben