|
The plan was to cut the shape of the two sides in 1mm aluminium and then cut the shape of the central portion which has a variable width to enable it to be inserted into place. The tabs included on the side pieces would then be joggled so the central portion was effectively flush with the side pieces. This plan was formulated before I had a good look at my joggler, which requires a tab of at least 12mm to work. I do not have 2 x 12mm to play with (the finished article will vary in width between 10mm and 40mm). I now have to devise a method of rebating the tabs close to the bend by 1mm. The joggler I have has removable jaws so maybe I just make some new jaws that will enable the rebate within 1 to 2mm of the bend????
|