Well PB can stuff themselves so its now like radio for the moment until a proper broadcast can be shown but Blog covers it generally.
Got my Stein Dinse parts today and as per usual service is fantastic and to be honest post at £9 overseas very quick UPS is creditable.
The triangular oil line plate made billet this time not cast is now painted black vht.
The seat cowl has the brackets and screws on and now fixed to the seat.
https://s14.postimg.org/ltq2eul4x/IMG_2100.jpg
The oil cooler hose has the clip and Gumi rubber in place and attached to the starter motor mount bolt and now understand that the clip is a double as in fits the airbox breather fish tail end too.
https://s21.postimg.org/yw4xazabb/IMG_2097.jpg
I have reversed the rear clip that holds the carb breather and that looks correct now and neater and more functional.
https://s15.postimg.org/mjdcu59az/IMG_2101.jpg
I also for now unless I get a new power cable set have improved the look of the rear earth lead as one end had insulation tape covering split rubber end cover. Removed it to check cable and all is good so replace with heat shrink on both ends to make it look as it should.
Ordered 4 more bearings for the camshaft 6004 c3 x 2 and 6003 c3 x 2 as although they were knocked out by a ducati specialist and run fine I don't want the risk of fail or wear for mere £18. Just need the oil seals but the writing was so tiny I never got it all and was unsure about material type so Moto Rapido for them to be sure.