View Single Post
Old 17-05-2016, 05:48 PM   #8
blackthorn
Guest
 
Posts: n/a
So today i sorted out the wiring for the indicators. It began with doing a continuity test which showed that there was nothing there, not a sausage! So i started to strip back the loom and it turns out the original owner hadn't finished hooking stuff up before wrapping the loom back up...



The green/white wires weren't attached from just after the loom plug so neither front/rear worked on the right where as the black/white for the left side was wired into the front one but not the rear so had to splice them together.



I did solder eveything but my soldering isn't worth of pictures












Waiting on diagnostic stuff arriving then it's time to get set in about it to get it running properly...
  Reply With Quote