Quote:
Originally Posted by kevrobot
I'll take a peek of that. Thanks mate.
On a good note, my hands are dirty again, on a bad note, the m10 bolt trick didn't work. I'm wondering if it would harm the alloy if I weld up some pieces to the sleeves and batter them out as the bolts/socket/washer combo kept slipping after a few bashes.
Cheers again for the help mate, everything is worth a punt.
Kev
|
My initial try with the standard method failed. I then tried the drilling and trying to hacksaw through the wall to weaken it as dremel failed. You will mark the alloy if not careful. I then tried my method successfully and they came out alright and the sides were as new no rust either. It almost needs like a T shape to hook under the wall and either a slide hammer or press out.