Quote:
Originally Posted by Albie
How about you accepting them free you sent me a hose and do stuff for me. They cost me £20 to replace and if I am honest only slightly better but the weird thing is 3 of them have machined on one edge and one had two cast ends. I kept the ones that are better but mate they are 5mm thick and tbh just need a dressing over and if I were not doing it to original they would be better polished up alloy or re anodised.
In payment can you turn me up a 12mm diameter stainless tube with a m8 through hole and 25mm long. Its for me to weld back on to the exhaust clamp and will be cut in half after welding and half with be cleared through.
|
Yep, I can do that, assuming that I have a bit of suitably sized stainless in the shed .. which I probably do but I'm away from home at the moment so can't check.
I need to get on the lathe anyway to make some bits for smiffy.
Am I correct to assume that, despite the one-sided machining, there's enough material left for either cap to fit on either side of the swinger without compromising anything ?
If so, then that will do very nicely.
Thanks mate.
And, as you said on another thread, "that's what we like about UKMOC".
In fact, this will add to my ongoing collection of bits on my bike that have come from other club members .... I'm well in to double figures now (including your old Corbin seat as a matter of fact). ..must start a thread about that sometime.