The right side can flaps about, the left not so much but with heat, vibration & movement I can see it being a problem on both.
I agree the best solution would be springs and it's an easy enough job to do so I'll be welding some loops on.
As for the screen, I've made a couple of 'L' shaped brackets that bolt to the side holes and then to the 6mm threaded holes in the front of the yoke, so just those and the headlight bolts are all that's required to remove - an easy enough job but it does leave the rear of the dash exposed or at least the ally mounting plate and warning lights so I will be leaving it on, at least initially. I think it looks OK personally and some wind protection is always good.
Often planned to go to Ashby Folville but never made it, despite it only being 10-15 minutes away. Will try to get over sometime this year.
