Thread: M750 project
View Single Post
Old 14-12-2011, 07:51 AM   #32
Lima071
Guest
 
Posts: n/a
I have been looking at altering the air intake on my streetfighter 900ssie project, and have found that you need to look at the system as a whole.
I like the long single cone, and you could balance the power distribution by reconfiguring the air intakes.
The 'washer' I talked about is a plate valve, and would help retain back pressure on the rear cylinder which is lost due to a lack of length, however I have then found out about intake length.
All of this might be common knowledge, but as my 900 is my first project, your build is of great interest and value to me.
Keep going mate.
  Reply With Quote