Quote:
Originally Posted by analogue_rogue
i got some performance ones.. the only thing im worried about on these forks (having only done standard ones not upside down forks) is the special tools that haynes keep harping on about!
|
The special tools arent that special to be honest.
A mate and a pair of screwdrivers will do most of it.
For a seal driver pop down to B&Q or the like and buy a short length of plastic water pipe, cut off a 75mm length and cut that lengthways in two. Put the two pieces around the fork leg and hold them together with a cable tie then use them as a slide hammer to drive the seal down into the upper leg.
Oh, and to get the inner leg to pull out of the outer leg give it a damn good yank, when that doesnt work, yank it harder.