Different master cylinders on M600

[Wildfire]

So in addition to my wanted post, I want to change the brake and clutch master cylinders when I fit clip ons. I'll either need spacers or new cylinders.

I figure I may as well improve the brakes and clutch, especially as I can't find any spacers.

I know the usual route is the Goldline cylinders, but are there any others I can use? I've found quite a few ST4 cylinders.

[jonzi]

I have radial brembo's. Not sure what they from.

Pretty sure you can put what you want on.

[Darren69]

There are some cheap Chinese radial masters on ebay. don't know what they are like though. Its probably not something you want to skimp on.

[Darren69]

Actually they're not radial, now I've had another look they're axial but remote res type and cheap as chips.

http://www.ebay.co.uk/itm/CLUTCH-BRAKE-MASTER-CYLINDER-7-8-KAWASAKI-HONDA-YAMAHA-SUZUKI-PROJECT-/221691927534?pt=UK_Motorcycle_Parts_13&hash=item339dde5bee

[Wildfire]

I did see these, but after my experience with Chinese levers, I think I'll go for some Brembos from an ST or similar. Athough I do fancy putting on a radial cylinder from a Streetfighter...

Maybe overkill for a single Caliper and disc?

[Kato]

http://www.biketorqueracing.co.uk/brakes/brembo-radial-master-cylinders/brembo-master-cylinder-twin-disc-brembo-callipers/xr01111.

[Dirty]

Don't mess about, this is the one you need :) http://www.biketorqueracing.co.uk/brakes/brembo-radial-master-cylinders/brembo-master-cylinder-twin-disc-brembo-callipers/xr01111.

[Wildfire]

I wish. I quite fancy one on my MV, then if I cold use the MV one on the Monster...