View Full Version : rod ends
scrapps
12-03-2012, 02:40 PM
Does anybody know where i could get the rod ends for the hight adjust rod on a 900ie that are not the mad price i was given by a Ducati dealer.
Or the part number/sizes so i could try to source.
Rally
12-03-2012, 02:52 PM
hi Scrapps, I have used these people before. http://www.rotaprecision.com/pages/rodobal.html
Funkatronic
12-03-2012, 03:12 PM
give rosso corse a call mate
ray often has bits like this of bikes they break
i think louigi moto break bikes too
Does yours have a tie-rod or hoop suspension linkage? 900ie was made right on the switchover.
search the forum for "rose", as in rose-joint
http://www.ukmonster.co.uk/monster/showthread.php?t=43522&highlight=rose
http://www.ukmonster.co.uk/monster/showthread.php?t=40949&highlight=rose
http://www.ukmonster.co.uk/monster/showthread.php?t=36080&highlight=rose
scrapps
12-03-2012, 03:50 PM
Does yours have a tie-rod or hoop suspension linkage? 900ie was made right on the switchover.
search the forum for "rose", as in rose-joint
http://www.ukmonster.co.uk/monster/showthread.php?t=43522&highlight=rose
http://www.ukmonster.co.uk/monster/showthread.php?t=40949&highlight=rose
http://www.ukmonster.co.uk/monster/showthread.php?t=36080&highlight=rose
Mine is the tie rod type same as S4 it has a ally link rod.
quoted £68.00 each for rod ends :eyepopping:
Sam69
12-03-2012, 04:36 PM
http://mcgillmotorsports.co.uk/ go for the high end rose joint they are made from T45 with teflon inserts.
Pomp1
12-03-2012, 04:57 PM
Marksman bearings.
you should be able to walk into almost any motor/bearing factor and pcik some up. Remember one has a reverse thread though.
Xenocide
17-04-2012, 03:11 PM
What's wrong with yours? They don't really wear. Try rotating the little antlers and put some oil down there and work it in. I used a lithium grease but i guess engine oil would work ok.
Phatty
17-04-2012, 03:40 PM
Aurora are a good manufacturer to look for.
scrapps
17-04-2012, 03:58 PM
Mine were not worn but jammed on the hight adjusting rod. tried to undo them but stuck solid
if i do want them out i would damage them doing so.
I have not adjusted the bike but will do when i get time to sort it and replace the ends.
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.