View Full Version : 94 m600 parts
slipper40
04-05-2011, 12:59 PM
cam belt covers, paint is scabby £20 each or £30 for 2 you pay postage on all items
engine cases need a paint £30 a side
tacho drive and cable £15
front head complete £50
rear head complete £50
rear bore and piston £50
front bore i can see marks on the bore on one side so will let it go for postage only
i will strip bottom end and sell unless some one wants the lot it is all very smooth..the starter , geny etc have been retained by me... i think these prices are cheap and helpfull to others but if you no otherwise give me a shout cheers steve
slipper40
05-05-2011, 05:08 PM
http://i127.photobucket.com/albums/p140/slipper40/moresnaps050.jpg
http://i127.photobucket.com/albums/p140/slipper40/moresnaps043.jpg
http://i127.photobucket.com/albums/p140/slipper40/moresnaps045.jpg
http://i127.photobucket.com/albums/p140/slipper40/moresnaps047.jpg
http://i127.photobucket.com/albums/p140/slipper40/moresnaps046.jpg
revver
05-05-2011, 08:45 PM
Hi i have a 95 m600 is the tacho connected to the front cylinder head. I have seen a small plate but the scew is tight so i have not looked under it. Cheers.
slipper40
05-05-2011, 09:55 PM
Hi i have a 95 m600 is the tacho connected to the front cylinder head. I have seen a small plate but the scew is tight so i have not looked under it. Cheers.
hi yeah yo have to take that screw out then the little tab that sits in a groove on that cap, then tease out the cap
revver
06-05-2011, 10:09 PM
By the driver do you mean the tacho clock. . Will be doing it up at end of year or so so just sourcing parts ready
slipper40
09-05-2011, 07:34 PM
By the driver do you mean the tacho clock. . Will be doing it up at end of year or so so just sourcing parts ready
hi no , the gearing ie the drive gear that goes into the hole under the cap we were talking about, and the cable,,,,,,,,,
revver
09-05-2011, 08:15 PM
Hi thanks. What tacho clock do you fit all the clocks i've seen on flee bay are the same as i have with no tacho and i'm not sure about after market ones. Also would you happen to have a pic of the m600 unchopped without seat on as i am trying to put it back to original ish. Thanks, revver.
slipper40
09-05-2011, 08:24 PM
Hi thanks. What tacho clock do you fit all the clocks i've seen on flee bay are the same as i have with no tacho and i'm not sure about after market ones. Also would you happen to have a pic of the m600 unchopped without seat on as i am trying to put it back to original ish. Thanks, revver.
you can take the tacho /clocks off an ss or some of the guy's on here may have other ideas , i will take some photos tomorrow for you of the backend:mand:
vBulletin® v3.8.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.