High Level pipes - Swing arm

[rac3r]

Quick question: My Monster has High Level Termis and the left hand side (gear leaver side) link pipe is touching the swing arm, is that normal/ok?

[gary tompkins]

No it isn't - maybe the fit needs adjusting or you are missing some spacers?

[Albie]

There is a spacer kit included but sometime when sold old these get lost. Use big washers to adjust small adjustments or it could be top mount pulling it inwards.

[rac3r]

I've just had a proper look (instead of just feeling for the gap) and it's not touching, there is a gap of about 3/4 mm. Is that ok? It's still not as much as the other side

[Albie]

No thats fine. 1mm and I would maybe check out if could open the gap. Ducati and termis are awful fitment. Always different left to right even my new ones are.:eek:

[rac3r]

Tried to measure it properly but it's a bit difficult in the dark :chuckle: I think it's about 3/4mm and the other side is about an inch!

[manwithredbike]

bounce on it and listen for knocking. check if there's any damage or marks on the pipe or swing arm

[rac3r]

bounce on it and listen for knocking. check if there's any damage or marks on the pipe or swing arm

The bike is parked close to the wall so it's a bit hard to see at the moment but when I checked there were no marks on the swing arm or the chain adjustment sticker, I'll try the bounce thing tomorrow :thumbsup: