pegboy
17-03-2009, 10:54 AM
I finally arrived home yesterday from a long vacation and got to work on the bike today to get riding again, i am currently in the middle of fitting the R&G Crash Protectors to my 98 M600 and it does not seem right to me, this is my problem
The tie bar (Through Bolt) connects to the Stainless steel ends, which connects to the bobbins, the S/S ends are tapered on the frame side which i issume that tightens up in the frame, mine sit out about 7mm each side, therefore i would think the engine would not be secure. Is this correct and would i need to machine them down to fit tight in the frame?
Many Thanks
The tie bar (Through Bolt) connects to the Stainless steel ends, which connects to the bobbins, the S/S ends are tapered on the frame side which i issume that tightens up in the frame, mine sit out about 7mm each side, therefore i would think the engine would not be secure. Is this correct and would i need to machine them down to fit tight in the frame?
Many Thanks