BluprintZ
06-09-2008, 02:57 PM
For the winter re-build, one of the mods i want to do is fit renthal drag-bars.
Obviously, with the stanchions poking out of the top yoke quite a few inches, they need to be dropped down enough for the bars to fit on the original clamps.
I seem to remember a post about a jack-up kit for the rear damper, i assume i will need to fit one, so as to bring the front and rear up to the right level.
My forks have the damping and rebound controls on the top, so they will also need to be taken into consideration.
Anyone got any ideas on measurements etc?
Obviously, with the stanchions poking out of the top yoke quite a few inches, they need to be dropped down enough for the bars to fit on the original clamps.
I seem to remember a post about a jack-up kit for the rear damper, i assume i will need to fit one, so as to bring the front and rear up to the right level.
My forks have the damping and rebound controls on the top, so they will also need to be taken into consideration.
Anyone got any ideas on measurements etc?