Headhunter
16-05-2008, 07:59 PM
After fitting my new rear-sets I now have a whole on each side which needs filling (left-hand side has the old bolt fitted, as it's part of the sidestand).
It's the bolt hole just next to the brake - used to hold the stock rear sets in place -
http://s302.photobucket.com/albums/nn92/wj731/?action=view¤t=Bolt.jpg
Ordered this from Probolt - Stainless Steel Dome Head/Fairings Bolts M10 (1.25) x 25mm Ref: LSSFB1025F , which is the right width/length.
First part of the thread went in and then it's too tight, as if its cross-threaded.
I know it says dome head/faring bolts but all the measurement on the website are right.
Is it anything to do with the pitch? Does anyone know the right pitch???
It's the bolt hole just next to the brake - used to hold the stock rear sets in place -
http://s302.photobucket.com/albums/nn92/wj731/?action=view¤t=Bolt.jpg
Ordered this from Probolt - Stainless Steel Dome Head/Fairings Bolts M10 (1.25) x 25mm Ref: LSSFB1025F , which is the right width/length.
First part of the thread went in and then it's too tight, as if its cross-threaded.
I know it says dome head/faring bolts but all the measurement on the website are right.
Is it anything to do with the pitch? Does anyone know the right pitch???