BELLY PAN touching exhaust

[alsduc]

hI

Ive just fitted my CF Monza Belly pan from spareshack to my S2R. Unfortunately the exhaust is touching the belly pan along one side. It was a struggle to fit round the exhaust which i can only presume is down to the fact that my termi exhaust uses a larger diameter de cat pipe then standard.

Is it okay if its touching the carbon or will it melt and cause a mess and or fire!!!!:fiery:

Any comments welcome.

Cheers

Alex

[dunlop0_1]

Easy(ish) to fix. I stuck some masking tape on and marked around where the exhaust was touching. Then using a dremel type tool (or a file/hacksaw blade) cut off the offending bit and then smoothed the edges with 240 grit wet or dry. Sorted.:idea:

[dlloyduk]

My Fibreglass pan burned 1st time on. I used a soldering mat from B&Q wrapped round and secured with lock wire.

[alsduc]

My Fibreglass pan burned 1st time on. I used a soldering mat from B&Q wrapped round and secured with lock wire.

I surpose exhaust wrap would do the same without compromising the bellypan.

Anyone used exhaust wrap and how does it stay on the exhaust?

[singletrack]

Did you manage to sort this out Alsduc? - I have the same problem with mine.
I can't cut the bellypan out cos too much of it is too close to the decat pipe.

[Stafford]

Just lose the De-cat pipe, unleash the power :shocked:

[singletrack]

Just lose the De-cat pipe, unleash the power :shocked:

That might leave a bit of a gap between the termis and the engine. I'm deaf enough as it is!